Renault premiun 2008 450 DXI fault codes showing

Hello, having these fault codes show on the renault premium 450 DXI 2008 model (volvo engine believe), and 6x2 layout.

Also have cruise control lever on steering control fault. (any ideas how to fix or replace) comes up as Steering wheel control fault).

any ideas, max RPM is 2200 and still engine ok with power.

AD blue was disabled long time ago with sensor added and these developed while past this. AD blue light goes out on startup ok

Not sure how to add in pictures yes

1st fault code, from EMS like an injector picture showing, MID:-128, SID:32, FMI:7

2nd fault code like a heartbeat grapgh from hospital for heartbest, from VECO, MID:144, SID:243, FMI:5

3rd fault APM (air pressure / sensor assume), MID:185 PSID:19 FMI:0

air one also shows “Workshop Air” picture come up also.

Any ideas appreciated without going to Renault to do the diagnostic with computer etc.

MID 128. SID 32. FMI 7. Turbo waste gate fault. Normally comes up with “Performance Loss” on the dash but goes perfectly o.k. Valve is on the n/s of engine towards the rear slightly above the fuel pre filter and PAS pump.

MID 144. SID 243 FMI 5. Cruise control fault. 99% of the time it’s the buttons either side of the steering wheel.

MID 185. PSID 19. FMI 0. It has/had or thinks it’s got an air leak and the Compressors not cutting out/in. Normally displays “Immediate Stop in 2 Hours” because it thinks the dryer cartridge is saturated. Can be reset by resetting the APM filter in Maintenance on the dash menu.

Steve

Hi cheers for that, will check them and se, yes engine is still strong and rev to 2200rpm max so performance loss not seen as still pulling heavy trailers ok

yes the new message came up today, stop within 2 hrs for the air fault also.

Is it simple to reset the air fault or do you need diagnostic plugged in to reset the air fault

yes cruise control does seem have issue sometimes. Any ideas on how to resolve teh button fix. Is it just switch cleaner you need or new parts (eg dirt of something got into the button)

I assume if wastegate is solenoid, need new part, not famialr with the larger hgvs (only ran smaller older trucks before) but will check it out and see if something we can do ourselves

thanks for the detailed help, much apprecaited

chris35:
yes cruise control does seem have issue sometimes. Any ideas on how to resolve teh button fix. Is it just switch cleaner you need or new parts (eg dirt of something got into the button)

My guess is that this will be the up/down switch on the left hand side of the steering wheel, I believe the replacement part is around £60.